FTM-400 Radio Software

The ADMS-M400 software allows you to program memory channels and menu settings of the Yaesu FTM-400 radio. 

ADMS-M400 works with authentic versions of the FTM-400 radio worldwide. 


Software - Program memories and other setting of the Yaesu FTM-400 radio. 
Works with Windows XP, Vista, Windows 7 (32 and 64 bit) or Windows 8 and 8.1 (full version)


Works with a MicroSD card for data transfer to the radio.



In the wizard you will:
1.Put a blank, recordable CD in your CD writer.
2.Follow the steps as they are presented on the screen.

Once the Wizard has finished:
1.Run setup from the new CD.
2.Copy the string that is presented on the serial number screen.
3.Return to this page through the link in the original e-mail, if it is not still open.
4.Paste that string into the space at the bottom of this page.
5.The serial number will be presented on the screen and will be sent to you in an e-mail addressed to the same e-mail address used for the original order.
6.Use that serial number to complete installation of the programmer from the CD.
7.Store the CD carefully. This is the only copy you are allowed to make just s if you had purchased a programming kit with one factory CD in it. You'll use this CD if you need to install again.

Note: You will need the serial number any time you install from this CD.You can retrieve the same serial number from the site by returning through the link in the original e-mail should you need that information again. The serial number will work only with the CD you are creating now. Store it carefully to ensure that you have installation media in the future should it be needed.

Send my e-mail and i give you key! pauhh@hot.ee